OMNIX350HG

Còn hàng

Tổng quan

Overview Tripp Lite's OMNIX350HG offers medical-grade UPS protection with built-in line interactive voltage regulation, intelligent monitoring and unattended shutdown capability. IEC320 plug & outlets, plus built-in isolation transformer with Faraday shield offers full isolation and removes common mode noise. Tested to CE/IEC 60601-1 as medical electrical equipment. 350VA power handling capacity supports computers, inter-networking equipment and other critical loads during commercial power failures. Line interactive voltage regulation corrects brownouts as low as 159V back to normal 230V levels, saving battery reserves for use only during complete power failures. Includes, 2 line phone surge...

Overview

 

Tripp Lite's OMNIX350HG offers medical-grade UPS protection with built-in line interactive voltage regulation, intelligent monitoring and unattended shutdown capability. IEC320 plug & outlets, plus built-in isolation transformer with Faraday shield offers full isolation and removes common mode noise. Tested to CE/IEC 60601-1 as medical electrical equipment. 350VA power handling capacity supports computers, inter-networking equipment and other critical loads during commercial power failures. Line interactive voltage regulation corrects brownouts as low as 159V back to normal 230V levels, saving battery reserves for use only during complete power failures. Includes, 2 line phone surge suppression and built-in USB communications port that works with PowerAlert Software and cabling to provide automatic unattended shutdown of connected network and PC applications.

Features

  • Ideal UPS protection for applications in medical patient-care areas where CE/ IEC 60601-1 electrical medical equipment is required
  • Line-interactive voltage regulation corrects brownouts as low as 159V without using battery power
  • IEC320 plug and outlets offer added degree of safety and reliability to input/output connections
  • Full line isolation prevents shock potential and operational problems in sensitive electronic equipment
  • Resistant to electrostatic discharge
  • Supports loads up to 350VA/225 watts
  • 37 minutes half load runtime (with 175VA load), 15.5 minutes full load runtime (with 350VA load)
  • 6 protected outlets; 6-inch dongle with IEC C14 inlet
  • C14 inlet accepts user-supplied AC power cord with grounded country-specific plug
  • 1-USB port for monitoring interface
  • Complete surge protection, line isolation and EMI/RFI noise filtering
  • 2 phone line surge suppression for modems, fax machines and other phone accessories
  • Complete remote monitoring cabling included, PowerAlert UPS management software available via free download
  • 4 diagnostic LEDs indicate AC present, on battery, voltage correction & battery low/replace
  • Battery replacement door and back panel equipotential connection (grounding lug)
  • Ground Potential Equalization Connector: POAG-S6/20

 

OUTPUT
Output Volt Amp Capacity (VA) 350
Output Watt Capacity (Watts) 225
Nominal Output Voltage(s) Supported 220V; 230V; 240V
Nominal Voltage Details 230v nominal inverter output voltage
Frequency Compatibility 50 / 60 Hz
Frequency Compatibility Details Automatic frequency selection
Output Voltage Regulation (Line Mode) -18%, +8%
Output Receptacles (6) C13
Output AC Waveform (Battery Mode) PWM sine wave
INPUT
Rated input current (Maximum Load) 1.8A
Nominal Input Voltage(s) Supported 230V AC
UPS Input Connection Type C14 inlet
UPS Input Connection Description C14 inlet accepts user-supplied AC power cord with grounded country-specific plug
UPS Input Cord Length (ft.) 6 inch dongle, 16 gauge
UPS Input Cord Length (m) 1.83
Recommended Electrical Service 10A 230V
Voltage Compatibility (VAC) 230
Input Phase Single-Phase
BATTERY
Full Load Runtime (min.) 15.5 min. (225w)
Half Load Runtime (min.) 37 min. (115w)
DC System Voltage (VDC) 12
Battery Recharge Rate (Included Batteries) Less than 7.2 hours from 10% to 90%
Internal UPS Replacement Battery Cartridge RBC52(quantity 2)
Battery Access Battery access door allows hot-swap battery replacement without powering connected equipment off
Typical Battery Lifespan 3-6 years, depending on usage
Expandable Runtime No
VOLTAGE REGULATION
Voltage Regulation Description Line interactive UPS offers a single boost level of brownout correction to maintain usable, computer grade output
Undervoltage Correction Input voltages between 159 and 199 are boosted by 14%
USER INTERFACE, ALERTS & CONTROLS
Switches Yes, includes 2 front panel mounted push-button switches for system enable, self-test and alarm cancel functions
Audible Alarm Audible alarm indicates power failure conditions, silenceable via alarm cancel switch. Once cancelled, alarm will resume when approximately 2 minutes of battery operation remain (assuming full load)
LED Indicators 4 LEDs indicate line power, battery power, overload and battery low/replace status
SURGE / NOISE SUPPRESSION
EMI / RFI AC Noise Suppression Yes
AC Suppression Response Time Instantaneous
Dataline Suppression 2-Line Tel/DSL
PHYSICAL
Installation Form Factors Supported with Included Accessories Tower
Installation Form Factors Supported with Optional Accessories Wallmount(UPSWM - tower mounting kit)
Primary Form Factor Tower
UPS Power Module Dimensions (hwd, cm) 26.9 x 13.1 x 18.8
UPS Power Module Weight (kg) 11.5
UPS Shipping Dimensions (hwd / cm) 35.9 x 26.5 x 20.9
Shipping Weight (kg) 12.3
Cooling Method Convection
UPS Housing Material PVC
ENVIRONMENTAL
Operating Temperature Range +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature Range +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity 0 to 95%, non-condensing
AC Mode BTU / Hr. (Full Load) 15.6
Battery Mode BTU / Hr. (Full Load) 124.5
COMMUNICATIONS
Communications Interface USB
LINE / BATTERY TRANSFER
Transfer Time 5 milliseconds AC to battery; 8 milliseconds battery to AC
Low Voltage Transfer to Battery Power (Setpoint) 159
High Voltage Transfer to Battery Power (Setpoint) 266
SPECIAL FEATURES
Grounding Lug Ground Potential Equalization Connector: POAG-S6/20
Cold Start (Startup in Battery Mode During a Power Failure) Cold-start operation supported
CERTIFICATIONS
UPS Certifications CE; Tested to UL60601-1 (medical grade)
Certifications Tested to CE/ IEC 60601-1 (Series AGOM6832), Class B (emissions)
WARRANTY
Product Warranty Period (International) 2-year limited warranty
Product Warranty Period (Mexico) 2-year limited warranty
Product Warranty Period (Puerto Rico) 2-year limited warranty
Find Us On FaceBook